Rheem GAS BOOSTED SOLAR WATER HEATER Specifications download pdf (Page 2)

PATENTS

This water heater may be protected by one or more patents or registered designs.

TRADEMARKS

Registered trademark of Rheem Australia Pty Ltd.

™ Trademark of Rheem Australia Pty Ltd.

Note: Every care has been taken to ensure accuracy in preparation of this publication.

No liability can be accepted for any consequences, which may arise as a result of its application.

WARNING: Plumber – Be Aware

The solar hot and solar cold pipes between the solar storage tank and the solar collectors MUST BE

of copper. All compression fittings must use brass or copper olives.

The full length of the solar hot and solar cold pipes MUST BE insulated.

The insulation must:

 be of a closed cell type or equivalent, suitable for a solar water heating application and capable

of withstanding the temperature of the water generated by the solar collectors under stagnation

conditions

The specification of the chosen insulation material should be checked with the insulation

manufacturer prior to installation as different materials may vary in temperature tolerance.

 be at least 13 mm thick, however thicker insulation may be required to comply with the

requirements of AS/NZS 3500.4

 be weatherproof and UV resistant if exposed

 extend through any penetrations in the eaves, ceiling and roof

 cover valves and fittings in the solar hot and solar cold pipe work

 be fitted up to and cover the connections on both the solar storage tank and the solar collectors.

Note: Failure to observe these requirements increases the risk of freeze damage.

Uninsulated pipe work, including concealed in cavities and roof spaces or where it may be in contact

with a metal roof, may lead to freeze damage. There is NO WARRANTY for freeze damage if the

solar hot and solar cold pipes are not insulated in accordance with the installation instructions.

The insulation is essential to assist in providing freeze protection, will offer corrosion protection to a

metal roof against water runoff over the copper pipe, assist in avoiding accidental contact with the

solar pipe work as high temperature water can flow from the solar collectors to the solar storage tank

and also reduce pipe heat losses.

The insulated copper pipe work:

 should be fixed at suitable locations to prevent or reduce the possibility of noise from water

hammer and vibration from occurring

 is not to be placed or installed in contact with plastic pipe work.

Likewise, plastic pipe work is not to be placed or installed in contact with the insulated copper

pipe work after the solar circuit is installed.

Plastic pipe MUST NOT be used, as it will not withstand the temperature and pressure of the water

generated by the solar collectors under stagnation conditions. The solar collectors can generate

extremely high water temperatures up to 150°C and high water pressure of 1000 kPa. Plastic pipe

cannot withstand these temperatures and pressures and MUST NOT be used. Failure of plastic pipe

can lead to the release of high temperature water and cause severe water damage and flooding.

A non return valve MUST BE installed on the cold water line to the solar storage tank AFTER the

cold water branch to a temperature limiting device. Due to the higher water temperatures generated

under certain conditions in the solar collectors of this solar water heater, an additional effective back-

flow prevention device also should be used as an extra safeguard. Valve manufacturer RMC

recommends Dual Check Valve model N7150, as being suitable for this application.

Plumber: It is important to refer to and read in full the complete

“Warning: Plumber – Be Aware” statement commencing on page 42.

1 2 3 4 5 6 7 ... 59 60

Comments to this Manuals

No comments

Rheem GAS BOOSTED SOLAR WATER HEATER Specifications Page 2

Comments to this Manuals

Related products and manuals for Water heaters & boilers Rheem GAS BOOSTED SOLAR WATER HEATER