This EZ-Link system must be installed and serviced by a qualified person. Please leave this guide with the householder. Installation Instructions ®
EZ-LINK SYSTEM 10 Secure the EZ-Link cable with the clamp and screw provided, to: E16, M16, 018, 020, 612, 618, 620 models – the bottom right of
EZ-LINK SYSTEM 11 7. Connect the other end of the EZ-Link cable to the second water heater. Draw the cable through the cable grommet on the
EZ-LINK SYSTEM 12 1234ONDIP2OFF ON1234Water Heater no.2SK6668-46REV_AD 2/12Temperature Controller(s) ConnectedNo Temperature Controller(s)DIP SW
EZ-LINK SYSTEM 13 1234ONDIP2OFF ON1234Water Heater no.2SK6668-46REV_AD 2/12Temperature Controller(s) ConnectedNo Temperature Controller(s)DIP SW
EZ-LINK SYSTEM 14 1 2 3 41 2 3 4ONOFF ONDIP1SW1 SW2REMOTECONTROLLERTERMINALBoth Water HeatersDip Switch 4in the on (up) positionEz-Lin
EZ-LINK SYSTEM 15 1 2 3 41 2 3 4ONOFF ONDIP1SW1 SW2REMOTECONTROLLERTERMINALEz-LinkCableSecure cable withcable clamp & screwOptiona
EZ-LINK SYSTEM 16 EZ-LINK CABLE CONNECTIONCONTINUOUS FLOW WATER HEATER86,87 SERIES, 022,024,027 MODELS1 234OFF ONDIP1ON1 2 34EZ-LINKCABLEDIP S
EZ-LINK SYSTEM 17 EZ-LINK CABLE CONNECTIONCONTINUOUS FLOW WATER HEATER86,87 SERIES, 627 MODELSSK6668-47 REV_AD2/121 234OFF ONDIP1ON1 2 34(WITH
EZ-LINK SYSTEM 18 Typical Two Unit Manifold with Ez-Link Connection MANIFOLD INSTALLATION - EZ LINK CONNECTIONTWO CONTINUOUS FLOW WATER HEATERS - 87
EZ-LINK SYSTEM 19 MANIFOLD INSTALLATION - EZ LINK CONNECTIONTWO CONTINUOUS FLOW WATER HEATERS - 872,874,876 SERIES 027 & 627 MODELS350eaves, balc
RHEEM AUSTRALIA PTY LTD - ABN 21 098 823 511 1 Alan Street (PO Box 6) Rydalmere NSW 2116 Australia PATENTS This system may be protected by one or mo
EZ-LINK SYSTEM 20 Typical Two Unit Manifold with Ez-Link Connection Indoor 362, 862, 864, 866 Series – 027 Models Refer to the Owner‟s Guide and
EZ-LINK SYSTEM 21 Typical Two Unit Manifold with Ez-Link Connection Indoor 362, 862, 864, 866 Series – 627 Models Refer to the Owner‟s Guide and
22 This page is intentionally blank.
23 This page is intentionally blank.
Revision Date: 2012 July 122139C 24
3 CONTENTS EZ-Link System ... 3 Dual Installation ...
EZ-LINK SYSTEM 4 EZ-Link System The EZ-Link™ system is designed to electronically control two continuous flow gas water heaters and have them operate
EZ-LINK SYSTEM 5 Notes: Only two continuous flow gas water heaters can be installed with an Ez-Link system. The Ez-Link system will vary the
EZ-LINK SYSTEM 6 Dual Installation The two continuous flow water heaters can be installed side by side with minimal clearance between t
EZ-LINK SYSTEM 7 Labels A warning label (121109) and an AGA approval label (121901) are supplied in the Ez-Link kit. Where the two water heater
EZ-LINK SYSTEM 8 Notes: A Kitchen controller only should be installed on other than a Rheem 612 to 627 or E16 model or Edwards 627 model if two cont
EZ-LINK SYSTEM 9 Ez-Link Cable Connection The references in steps 5 to 8 are to the: „Control Board M16, 018, 020 models with Ez-Link Connection‟ di
Comments to this Manuals