Rheem GAS BOOSTED SOLAR WATER HEATER User Manual download pdf (Page 23)

INSTALLATION – SOLAR STORAGE TANK

REDUCING HEAT LOSSES

The cold water line to and the tempered water and hot water lines from the water heater must be

insulated in accordance with the requirements of AS/NZS 3500.4. The insulation must be weatherproof

and UV resistant if exposed.

The pipe work between the solar storage tank and the solar collectors must be insulated in accordance

with the requirements of AS/NZS 3500.4. The insulation must be weatherproof and UV resistant if

exposed. The insulation must be fitted up to the connections on both the solar storage tank and the

solar collectors.

ANODE TYPES

The correct anode type for the water supply being used must be fitted in the water heater (refer to

“Water Supplies” on page 52). The black anode is fitted as standard.

Total Dissolved Solids in water supply to the water heater Anode colour code

0 – 40 mg/L Green

40 – 600 mg/L Black

600 – 2500 mg/L Blue

SADDLING - PIPE WORK

To prevent damage to the cylinder when attaching pipe clips or saddles to the water heater jacket, we

recommend the use of self-drilling screws with a maximum length of 12 mm. Should pre drilling be

required, extreme caution must be observed when penetrating the jacket of the water heater.

Note: Damage to the cylinder as a result of saddling to the jacket will void the warranty.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

No comments

Rheem GAS BOOSTED SOLAR WATER HEATER User Manual Page 23