Rheem Air Sourced 310 Specifications

Browse online or download Specifications for Water heaters & boilers Rheem Air Sourced 310. Rheem Air Sourced 310 Specifications User Manual

  • Download
  • Add to my manuals
  • Print

Summary of Contents

Page 1 - Installation Instructions

This water heater must be installed and serviced by a qualified person. Please leave this guide with the householder. Owner’s Guide and Installation

Page 2

REGULAR CARE 10 TEMPERATURE PRESSURE RELIEF VALVE This valve is near the top of the water heater and is essential for its safe operation. It is po

Page 3 - CONTENTS

11 WATER SUPPLIES This water heater must be installed in accordance with this advice to be covered by the Rheem warranty. This wat

Page 4 - ABOUT YOUR WATER HEATER

WATER SUPPLIES 12 CAUTION If the water supply has a TDS greater than 150 mg/L and a green anode has not been changed to a black anode, or if the TDS i

Page 5

13 SAVE A SERVICE CALL Check the items below before making a service call. You will be charged for attending to any condition or fault that is not r

Page 6 - OPERATING MODE MONITOR

SAVE A SERVICE CALL 14 HEAT PUMP IS NOT OPERATING Power must be available at the water heater and to the heat pump for the LEDs to glow or flash. If

Page 7 - TO TURN ON THE WATER HEATER

SAVE A SERVICE CALL 15 or  the red LED is flashing (other than 3 x red flashes with the green LED off, or a solid red glow, or a single red flash wi

Page 8

SAVE A SERVICE CALL 16 1, 2, 4, 5, 6 or 7 x Red Flashes – Green LED Is Off If the red LED is flashing either 1, 2, 4, 5, 6 or 7 x red flashes and the

Page 9

SAVE A SERVICE CALL 17 EXPANSION CONTROL VALVE RUNNING If an expansion control valve is fitted in the cold water line to the water heater

Page 10 - EXPANSION CONTROL VALVE

18 INSTALLATION THIS WATER HEATER IS FOR OUTDOOR INSTALLATION ONLY. THIS WATER HEATER IS NOT SUITABLE FOR POOL HEATING. INSTALLATION STANDARDS The

Page 11 - WATER SUPPLIES

INSTALLATION 19 WATER HEATER LOCATION The water heater is suitable for outdoor installation only. The water heater should be installed close to the

Page 12 - CHLORIDE AND PH

PATENTS This water heater may be protected by one or more patents or registered designs in the name of Rheem Australia Pty Ltd. TRADE MARKS ® Regist

Page 13 - SAVE A SERVICE CALL

INSTALLATION 20 MAINS WATER SUPPLY Where the mains water supply pressure exceeds that shown in the table below, an approved pressure li

Page 14 - HEAT PUMP IS NOT OPERATING

INSTALLATION 21 HOT WATER DELIVERY This water heater can deliver water at temperatures which can cause scalding. It is necessary and we recommend tha

Page 15

INSTALLATION 22 CIRCULATED HOT WATER FLOW AND RETURN SYSTEM A 551 310 model heat pump water heater should not be installed as part of a circulated hot

Page 16

INSTALLATION 23 TYPICAL INSTALLATON – OUTDOOR LOCATION Installation (typical) - Outdoor LocationsHeat Pump Air Sourced Electric Boosted Water Heater

Page 17

INSTALLATION 24 DIMENSIONS AND TECHNICAL DATA Dimensional DrawingHeat Pump Air Sourced Electric Boosted Water Heater. System number 551 310 Part nu

Page 18 - INSTALLATION

25 HEAT PUMP AND TANK ASSEMBLY STORAGE TANK AND HEAT PUMP MODULE The heat pump water heater is made of two main components, the storage tank and the

Page 19 - FREEZE PROTECTION

HEAT PUMP AND TANK ASSEMBLY 26 ASSEMBLY PROCEDURE Warning: The heat pump must be assembled, plumbed and filled with water prior to pow

Page 20

HEAT PUMP AND TANK ASSEMBLY 27 3. Air Louvre Removal: Using a Phillips head screw driver, remove the six (6) screws from each of the two air louvres

Page 21 - HOT WATER DELIVERY

HEAT PUMP AND TANK ASSEMBLY 28 6. Heat Pump Module Placement: Using two people, one person on each lifting bar, lift the heat pump module and place i

Page 22

HEAT PUMP AND TANK ASSEMBLY 29 9. Inlet Flexible Braided Hose: Attach the flexible braided hose marked “INLET” to the water fitting mar

Page 23

3 CONTENTS HOUSEHOLDER – We recommend you read pages 4 to 17. The other pages are intended for the installer but may be of interest. About Your W

Page 24 - Dimensional Drawing

HEAT PUMP AND TANK ASSEMBLY 30 11. Air Bleed Valve: Open the air bleed valve screw by rotating anticlockwise one turn. This will allow air to bleed f

Page 25 - HEAT PUMP AND TANK ASSEMBLY

HEAT PUMP AND TANK ASSEMBLY 31 BACKUPPLUGTANK SENSORCABLE PLUGIN POSITIONPOWERCABLEPOWERCABLEPOWERCONNECTORPOWERCONNECTORIN POSITIONCABLETIEBACKUPPLU

Page 26

32 CONNECTIONS – PLUMBING All plumbing work must be carried out by a qualified person and in accordance with the Standard AS/NZS 350

Page 27

CONNECTIONS – PLUMBING 33 EXPANSION CONTROL VALVE Local regulations may make it mandatory to install an expansion control valve (ECV) in the cold wate

Page 28

34 CONNECTIONS – ELECTRICAL The power supply to the water heater must not be switched on until the water heater is filled with water and a satisfact

Page 29

CONNECTIONS – ELECTRICAL 35 BOOSTER HEATING UNIT AND THERMOSTAT SETTING The water heater has a booster heating unit and thermostat. The booster heatin

Page 30 - ANTICLOCKWISE

36 MULTIPLE INSTALLATIONS A multiple installation of Rheem heat pump water heaters on a single manifold or multiple manifolds is pos

Page 31 - cable tie power cable

MULTIPLE INSTALLATIONS 37 TYPICAL INSTALLATION – MULTIPLE HEAT PUMP WATER HEATERS MULTIPLE HEAT PUMP WATER HEATERS TYPICAL INSTALLATIONLE

Page 32 - 

MULTIPLE INSTALLATIONS 38 MANIFOLD ARRANGEMENT Manifold Arrangement - Multiple InstallationHeat Pump Water Heaters Hot Manifold Assembly Manifo

Page 33 - CONDENSATE DRAIN

39 COMMISSIONING TO FILL AND TURN ON THE WATER HEATER The power supply to the water heater must not be switched on until the water heater is filled

Page 34 - CONNECTIONS – ELECTRICAL

4 ABOUT YOUR WATER HEATER WATER HEATER APPLICATION This water heater is designed for use in a single family domestic dwelling for the purpose of hea

Page 35 - 310L STORAGE TANK

COMMISSIONING 40 DIAGNOSTIC FEATURES OF THE HEAT PUMP CONTROLLER An operating mode monitor is located on the front of the heat pump module and houses

Page 36 - MULTIPLE INSTALLATIONS

COMMISSIONING 41 Notes Power must be available at the water heater and to the heat pump for the LEDs to glow or flash. Solid Red or 3 x Red Flashe

Page 37

42 This page is intentionally blank.

Page 38 - Heat Pump Water Heaters

43 RHEEM HEAT PUMP WATER HEATER WARRANTY - AUSTRALIA ONLY - HEAT PUMP WATER HEATER MODEL 551310 1. THE RHEEM WARRANTY – GENERAL 1.1 This warrant

Page 39 - COMMISSIONING

RHEEM HEAT PUMP WATER HEATER WARRANTY - AUSTRALIA ONLY - Revision Date: 2013 June 126524K 44 HEAT PUMP WATER HEATER MODELS 551310 3. WHAT IS COVER

Page 40

ABOUT YOUR WATER HEATER 5 HOW HOT SHOULD THE WATER BE? The system controls (compressor, evaporator and fan) will operate until a water temperature o

Page 41 - DRAINING THE WATER HEATER

ABOUT YOUR WATER HEATER 6 OPERATING MODE MONITOR An operating mode monitor is located on the front of the heat pump module and houses a green and a re

Page 42

ABOUT YOUR WATER HEATER 7 MAINS PRESSURE The water heater is designed to operate at mains pressure by connecting directly to the mains water supply. I

Page 43 - - AUSTRALIA ONLY

ABOUT YOUR WATER HEATER 8 PRECAUTIONS Where damage to property can occur in the event of the water heater leaking, the water heater must be

Page 44

9 REGULAR CARE MINOR SIX MONTH MAINTENANCE It is recommended minor maintenance be performed every six months by the dwelling occupant. The minor ma

Comments to this Manuals

No comments